The Facts About How to Laminate a Countertop - This Old House Revealed

Cut these strips with the keep piece off the lumber. Project the cutline inch past the edge (to represent the router bit's width). When utilizing a router, cut from delegated right as you face the edge (and the tool is upright), to keep the bit from pulling. Adhere the side pieces Utilizing a chip brush, apply contact cement to the back of the laminate strips for the counter's short sides and onto the substrate sides.

Permit the contact cement on both parts to dry to the touch. Take  Official Info Here  and position it over the side without letting it touch, ensuring it's evenly aligned all around. Working from one end to the other, stick the laminate to the substrate, smoothing it as you go.

Retouch uneven edges Utilizing the router switched on its side, cut off the overhanging edges of laminate, running the bit counterclockwise around the edges. Retouch irregular edges with a file or sander, keeping it flat on top of the particleboard and pressing far from the laminate. With the sides done, glue and cut the front edge.

Formica Laminate Sheets - Formica

Keep the bit complimentary of adhesive by occasionally unplugging the router and soaking the bit in water. Cover laminate back and substrate with contact cement Turn the leading laminate sheet facedown. Put contact cement onto the back and, utilizing a paint roller, spread out the adhesive over the entire sheet. Roll any excess onto the substrate.

Everything about Dimensions Laminate Countertop - VT Industries

Enable the contact cement to dry to the touch on both parts. Laminate the leading Lay wood scraps or dowels across the substrate every 12 inches or so. Flip the laminate so that it is adhesive-side down, and rest the sheet on top of the scraps without enabling it to touch the substrate.

Everything You Want to Know About Our Formica Countertops! - Yellow Brick  Home

Are Laminate Countertops Good as Green Counter Choices? - Ecohome

Beginning in the middle, remove a scrap and press the laminate down. Working out from the center, continue eliminating scraps and pressing the sheet into location, up until the whole sheet is adhered. Roll over the counter with the J-roller, utilizing firm strokes. Utilizing the trim router, cut off the excess around the border.